Loading of cast supporting structures of three-piece bogie 18-100 in the presence of defects on the surface of wheel rolling
https://doi.org/10.21780/2223-9731-2016-0-3-161-168
Abstract
Results of the loading study of support structures of bogies 18 - 100 with the presence of defects in the form of slides and uneven wheel wear on the rolling surface were shown. Research carried out by strain measurement. Strain gauges were installed in the area of spring and axle boxes openings of the side frames and bolster. Defects on the rolling surface formed at VNIKTI test site. Wheelset with defects rolls instead of the first wheelset in one of the bogies which was considered experimental. Stress levels are defined at values 1 and 3 mm for the sliders, 2 and 4 mm for uneven rolling. Trial runs were conducted during experimental train motion on direct track section, as well as on turnouts of 1/11 mark, when turning to a side track and in a curve of 600 m radius, at a speed range 30 to 100 km/h both forward and reverse. Stress levels in the most loaded areas of the side frame and bolster were set experimentally. It was shown that defects with limit-exceeding geometric parameters are a huge source of force loading of axle box openings of the side frames. The remaining areas of side frames and bolsters experience additional loading during dynamic impact interaction with the wheel defects and the rail, but the stress levels at these locations is 2 - 3 times lower than in the zone adjacent to the defective wheel. It was found that for the fatigue resistance of the side frames exploitation of cars with slides more than 3 mm is not allowed. During uncoupling of cars, when wheel with slides more than 3 mm is detected, it needs to carry out flaw detection of side frames by NDT methods.
About the Authors
O. G. Krasnov
Joint Stock Company “Russian scientific research and technological institute of rolling stock” (JSC “VNIKTI”)
Russian Federation
Russian Federation
G. S. Nozdrachev
Joint Stock Company “Russian scientific research and technological institute of rolling stock” (JSC “VNIKTI”)
Russian Federation
Russian Federation
А. S. Gasyuk
Joint Stock Company “Russian scientific research and technological institute of rolling stock” (JSC “VNIKTI”)
Russian Federation
Russian Federation
References
1. Kudryavtsev N. N. Issledovanie dinamiki neobressorennykh mass vagonov [Study of the dynamics of unsprung masses of cars]. Trudy VNIIZhT, vyp. 97. [Works of VNIIZhT (Railway Research Institute), is. 97]. Moscow, Transport Publ., 1965, 168 p.
2. Kudryavtsev N. N. Dinamiki dvizheniya kolesa s polzunom [Dynamics of wheel motion with the slider]. Vestnik VNIIZhT [Vestnik of the Railway Research Institute], 1960, no. 2, pp. 30 – 34.
3. Verigo M. F., Kogan A. Ya. K voprosu o protsessakh vzaimodeystviya neobressorennykh mass i puti [On the question of the processes of interaction between the unsprung mass and the track]. Vestnik VNIIZhT [Vestnik of the Railway Research Institute], 1969, no. 6, pp. 22 – 23.
4. Rules of technical operation of railways of Russian Federation. Approved by the order of Russian Ministry of Transport on December 21, 2010, № 286, 112p. (in Russ.).
5. TsV-944. Instructions for inspection, examination, repair and formation of wagon wheelsets. Moscow, Transport Publ., 2008, 84 p. (in Russ.).
6. Sokolov A. M. O formirovanii kompleksnoy programmy nauchno-issledovatel’skikh rabot po probleme izlomov bokovykh ram telezhek gruzovykh vagonov [On the formation of a comprehensive program of scientific research on the issue of lateral fractures of bogie frames of freight cars]. Byulleten’ ob’edinennogo uchenogo soveta OAO RZhD [Bulletin of Joint Scientific Council of JSC “Russian Railways”], 2012, no. 3, pp.3 – 11.
7. Kutyanina M. N., Reykhart V. A. K otsenke kachestva litykh bokovykh ram [On assessing the quality of cast side frames]. Vagony i vagonnoe khozyaystvo [Cars and car facility], 2012, no. 1, pp. 25 – 29.
8. Sen’ko V. I., Pastukhov I. F., Pastukhov M. I. Itogi kompleksnoy otsenki ostatochnogo resursa litykh detaley telezhek gruzovykh vagonov [Results of a comprehensive assessment of residual resource of cast parts of freight cars bogies]. Vestnik GTTU im. Sukhogo [Vestnik of Gomel State Technical University named after P. O. Sukhoy], 2006, no. 1 – 2, pp. 3 – 10.
9. Oganyan E. S., Krasyukov N. F. Usloviya bezopasnoy ekspluatatsii litykh detaley telezhek gruzovykh vagonov [Terms and conditions of safe operation of cast parts of freight car bogies]. Byulleten’ ob’edinennogo uchenogo soveta OAO RZhD [Bulletin of Joint Scientific Council of JSC “Russian Railways”], 2013, no. 3, pp.13 – 20.
10. Sen’ko V. I., Pastukhov I. F., Makeev S. V., Pastukhov M. I. O nesushchey sposobnosti nadressornykh balok telezhek gruzovykh vagonov [On support capacity of bolsters of freight car bogies]. Vestnik GTTU im. Sukhogo [Vestnik of Gomel State Technical University named after P. O. Sukhoy], 2009, no.1, pp.16 – 20.
11. Methods of fatigue testing. Bogie bolsters and side frames of cast two-axle bogies of freight cars for 1520 mm gauge railways. JSC “VNIIZhT” — JSC “NII vagonostroenia”, 2010, 14 p. (in Russ.).
12. Norms of calculation and design of wagons for Ministry of Railways 1520 mm gauge railways. Not self-propelled. Moscow, GosNIIV-“VNIIZhT”, 1996, 319 p. (in Russ.).
13. Krasnov O. G., Efimenko A. V., Akashev M. G. Vliyanie defektov na poverkhnosti kataniya koles na resurs bokovykh ram gruzovykh vagonov [Influence of defects on the rolling surface of wheel on the resource of side frames of freight cars]. Vagony i vagonnoe khozyaystvo [Cars and car facility], 2014, no. 2, pp. 45 – 48.
14. Kamayev O. B., Survilo А. B., Prikhod’ko А. P., Shakhov V. I. Veroyatnostnoe obosnovanie zapasov ustalostnoy prochnosti litykh detaley telezhek gruzovykh vagonov [Probabilistic justification reserves of fatigue strength of cast parts of freight car bogies]. Vestnik VNIIZhT [Vestnik of the Railway Research Institute], 1977, no. 3, pp. 26 – 29.
Review
For citations:
Krasnov O.G., Nozdrachev G.S., Gasyuk А.S. Loading of cast supporting structures of three-piece bogie 18-100 in the presence of defects on the surface of wheel rolling. RUSSIAN RAILWAY SCIENCE JOURNAL. 2016;(3):161-168. (In Russ.) https://doi.org/10.21780/2223-9731-2016-0-3-161-168
Views:
478
.jpg)
Email this article 